How To Change Oil Filter On 2017 Camry
Change The Oil on a 2017-upwardly Toyota Camry 4 Cylinder
This commodity is visible to only y'all.
Larn how to modify the oil on your 2017+ Toyota Camry (XV70) with a 2.5L 4 Cylinder A25A-FKS Engine. This engine is shared with the 2018+ RAV4, Avalon, and Lexus ES 250/260. We've got a stride past footstep how to with all the parts and tools you'll need.
Annotation: The Camry trim levels Hybrid, L, LE, and SE all utilise the 2.5L 4 cylinder engine. XLE, XSE) are available in both a v6 and inline 4 cylinder engine. The XLE and SLE are bachelor in both V6 and I4 engines, and then double check before you lot buy supplies.
Toyota calls for an oil change every 5,000 miles or 6 months (whichever comes offset) under normal apply.
- Oil Filter Wrench - may differ based on the filter you lot use
- Ratchet Set with 10mm and 14mm sockets
- Oil Take hold of Pan
- Oil fill funnel
- Rhinoceros Ramps OR a Hydraulic Jack and Jack Stands
- 4.8 qt. of 0W-16 Oil that meets API SN/RC Mobile1 0W-sixteen, Penzoil 0W-16, Valvoline 0W-sixteen,
- Oil Filter - Choose One: Toyota 90915-YZZF2, K&N PS-1003, or FRAM XG4967 or FRAM TG4967 / PG4967, STP S2878XL,
- Optional - Replacement Oil Bleed Plug Mishimoto M12x1.25, Fumoto F103SX Oil Drain Valve, Toyota 90341A0007 (M12x1.25)
- Oil drain plug gaskets Toyota 90430-12031
Get Started past Lifting the Machine
1
Lift the front of the vehicle using ramps or your jack and jack stands.
The Camry front end lift signal is easily seen at the center under the car. The side jack/stand points are indicated by the typical notches in the side trunk seams seen on most cars. Be careful and safe!
Remove The Oil Pan Access Console
2
Remove the four access panel screws.
Drain the Oil
3
Place your drain pan under the oil pan.
4
Remove the 14mm oil drain plug
5
Install a new drain plug and crush washer. Torque to nearly 30 ft-lbs.
6
Remove the oil filter using your favorite type of filter wrench.
seven
Screw the new filter on, tightening information technology per the instructions on the box.
For case: Mobil1 filter instructions say to seat the gasket and tighten one three/four turn.
Fill with New Oil
8
Using your funnel, refill the oil. It takes approximately 4.8 quarts.
Toyota asks for 0W-16 API SN/RC oil for the 2.5L 4 cylinder. 0W-sixteen is a somewhat harder to notice oil weight, so Toyota does say you lot can use 0W-twenty in a pinch, just should be replaced with 0W-16 at the next interval. I'grand able to find some suppliers on Amazon (equally listed above in the parts department).
nine
Check the oil level past removing the dip stick, drying information technology and re-inserting it.
Bank check the level by reading where the oil shows upwardly on the end.
End Up
10
Visually check the filter and bleed plug for leaks.
11
Re-install the slip plate and 4 screws.
12
Lower the machine back to the ground.
13
Start upwards the engine and sentinel the oil pressure light to brand certain information technology doesn't stay on.
fourteen
Re-bank check the oil level and check once more for leaks.
##How to Go Rid of Your Old Oil?##
Your local machine parts shop volition take your old oil as long every bit you don't mix it with any other fluids.
Get notified nigh new articles.
We don't sell or share your info.
How To Change Oil Filter On 2017 Camry,
Source: https://howtune.com/articles/561-change-the-oil-on-a-2017-up-toyota-camry-4-cylinder
Posted by: bowlinbouthad.blogspot.com
0 Response to "How To Change Oil Filter On 2017 Camry"
Post a Comment